Claw Rig
What you need to create a Claw Rig:
A hook of your Choice, we have used a R-Square,
Peel Coated Hooklink or Sinew Supple Braid,
Line Aligner B, Silicone Tubing
and a Latched Baiting Needle
Tie a Figure of Eight loop knot
Place the hooklink link into the Latch of the Baiting Needle and slide both pieces of the Silicone Tubing on to the Hooklink
Set the Hair length
Thread a Line ALigner B down the hooklink
Strip 5cm of coating from the Peel Coated Hooklink
(skip this step if using Sinew Supple Braid)
Cut two pieces of Silicone Tubing and
thread them on to a Latched Baiting Needle
Pass the hook point through the two pieces of
silicone Tubing
(be careful not to split it)
secure the hook using the Knotless Knot
Position the Line Aligner B over the eye of your hook.
make sure the silicone tubing is right around the bend of the hook:
it kicks over far quicker like this.
What we used:
Or Buy Ready Made
